Hoover HP13-80 help

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hoover HP13-80 help

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • September 25, 2007 at 8:59 am #30809
    Geoff1312
    Participant

    Hello hoover experts,

    Called to a hoover (HP13-80 310008720544 8354 G0001 Type FCE2)
    Machine dead, signs of burning on module, especially around relay.

    Replaced PCB ( pre programmed from connections pt No 09200430 ) Lights up, door locks then nothing on any prog. Ran test Prog. Gets to banks of LEDs flashing alternately but nothing else.
    Element ok, door lock bypassed, motor armature ( i.e. brush to brush o.k.)

    Now brick wall time! Any suggestions please.
    Thanks in anticipation
    Geoff

    September 25, 2007 at 3:24 pm #228536
    timdowning
    Participant

    Re: Hoover HP13-80 help

    Had a few do this when the pump is open circuit. If not that check with hoover that the board you fitted is the correct one.

    September 25, 2007 at 7:14 pm #228537
    Penguin45
    Participant

    Re: Hoover HP13-80 help

    09200430 fits machines up to 0519.
    09200856 fits machines from 0519 onwards.

    Your code is 0544 – you have the wrong board.

    Chris.

    October 8, 2007 at 3:56 pm #228538
    Geoff1312
    Participant

    Re: Hoover HP13-80 help

    Sorry for delay in reply, customer on holiday. Thanks for replies, sadly the pump was ok. Must require PCB as advised. This is a special order from Connect, customer not prepared to wait any longer. Purchased new machine from us needless to say not a Hoover! Hoovers loss.

    Thanks again
    Geoff

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.