Smart Drive 051 wont fill with water

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › Smart Drive 051 wont fill with water

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • October 2, 2007 at 9:45 am #31008
    hinerau
    Participant

    Hi there, my smart drive won’t fill with water when I press the start button.

    If I take the lid off and hold the small button in near where the lid was released, the water will start to fill for a few seconds and then stop. It will repeat the start fill/stop fill process a few more times until it stops all together. Once it stops, the third light from the top left will flash with a beeping sound.

    In diagnostic mode, I can get the cold and hot water to run into the machine, and then empty the water back out again.

    Any ideas? :rolls:

    Cheers
    Claire

    October 3, 2007 at 7:18 am #229365
    bigsmokepiker
    Moderator

    Re: Smart Drive 051 wont fill with water

    Simplest solution Would be A Faulty Out of Balance Micro switch
    Terminals Corrode & Washer thinks It is Out Of Balance
    It can Also be related to many other factors IE Main PCB or Rotor postion Sensor

    Run The Sticky & see if Can Post FAULT CODE

    October 3, 2007 at 10:04 am #229366
    hinerau
    Participant

    Re: Smart Drive 051 wont fill with water

    Hi there, Error Code 43. Just having a search now to see what it means and what to do.
    Cheers

    October 3, 2007 at 11:46 am #229367
    bigsmokepiker
    Moderator

    Re: Smart Drive 051 wont fill with water

    43 out of Balance Switch fault

    October 6, 2007 at 2:19 am #229368
    hinerau
    Participant

    Re: Smart Drive 051 wont fill with water

    Hi there, fixed the switch – it had a bit of corrosion, so thats all ok. Yay!! Now it wont spin. Boo!! Any ideas what this could be?

    October 6, 2007 at 2:27 am #229369
    hinerau
    Participant

    Re: Smart Drive 051 wont fill with water

    error code 37 – pump blocked perhaps?

    October 6, 2007 at 6:08 pm #229370
    Penguin45
    Participant

    Re: Smart Drive 051 wont fill with water

    Yup, pump block error. It’s a twist fit from underneath – power off if handling it.

    Penguin45.

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.