hotpoint wd440p

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › hotpoint wd440p

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 8, 2007 at 2:00 pm #31180
    Johnnyboy
    Participant

    hi all

    Iam having a problem with a hotpoint wd440p ,when i start the appliance on any programme after a few secs the appliance will open the inlet valve and the drain pump and the drier motor all at the same time ,(the 3rd an fourth lights from the top also flash on the fascia) fallt code ? have changed the module at the base of the appliance with no joy .

    anybody else had any experiance with this fault?

    thanks .

    October 8, 2007 at 4:19 pm #230170
    wilf
    Participant

    Re: hotpoint wd440p

    exactly the same fault this afternoon on off switch not working either you have to unplug this on a indesit WIDL126 as the machine was only 13 months old I advised to chace indesit as I suspected main board ( motors heaters tested ok. original fault started with ablocked pump)
    Let me know how you get on

    wilf

    October 8, 2007 at 8:07 pm #230171
    helo_75
    Participant

    f03 is an ntc fault

    could be a broken wire, or a faulty ntc itself… comes as part of the heater

    if youve changed the baord (with eprom) then its gotta be that

    hth

    October 8, 2007 at 8:08 pm #230172
    roy1
    Participant

    Re: hotpoint wd440p

    The 3rd & 4th led is the fault code for Nct short/open circuit, change the
    dryer thermistor & check wiring to thermistor and board.
    The fan, pump, and valve are switched on when a fault occurs

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.