DIPLOMAT DISWASHER FA FAULT CODE

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › DIPLOMAT DISWASHER FA FAULT CODE

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 9, 2007 at 8:09 pm #31227
    yowker
    Participant

    Hello 😀 I have a Diplomat ADP8332 which is coming up with the FA fault code. 🙁 First how do I reset it, secondly if it comes up again what do you think the fault may be.

    Thanks in advance for your advice. Stuart.

    October 9, 2007 at 8:34 pm #230318
    Penguin45
    Participant

    Re: DIPLOMAT DISWASHER FA FAULT CODE

    FA is the “Optical water indicator failure” fault. Unfortunately, this isn’t fitted to your appliance, so almost certainly a computer problem.

    You can clear the existing programme by holding down the start button.

    Penguin45.

    October 10, 2007 at 3:27 pm #230319
    yowker
    Participant

    Re: DIPLOMAT DISWASHER FA FAULT CODE

    Hello thanks for that 🙂 , I presume that there is not a reset procedure (I have found comments on web about switch off, then on, press prog. button 4 times, shut door, and it clears its problem). Do I therefore require an engineer 😥

    Cheers Stuart

    October 10, 2007 at 8:10 pm #230320
    Penguin45
    Participant

    Re: DIPLOMAT DISWASHER FA FAULT CODE

    That’s the reset procedure for the SMEG-built Diplomats – yours is a Whirlpool.

    Due to the cost of the PCB, I’d send for the pros – it might avoid an expensive mistake.

    Penguin45.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.