Fisher & Paykel MW059 no power, can’t find fuse

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › Fisher & Paykel MW059 no power, can’t find fuse

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 23, 2007 at 10:59 am #31611
    Kenton02
    Participant

    Hi

    Have absolutely no power.

    Does anyone know where the fuse is, or if in fact there is one?

    October 24, 2007 at 1:25 am #231854
    bigsmokepiker
    Moderator

    Re: Fisher & Paykel MW059 no power, can’t find fuse

    No fuse As Such
    Check pump (The Pump is part of the power supply) if pump is open circuit
    it will have to Be replaced (Resistance Should read 33 Ohm)
    Other Than that It will be the Main PCB (Motor Controller)
    If decide to replace Controller beware
    In some instances the Water inlet coils(Valves Should Read 64Ohms)can fail & Take out the PCB
    Its all bad news im afraid (Unless Its just the Pump)

    October 24, 2007 at 8:47 am #231855
    Kenton02
    Participant

    Re: Fisher & Paykel MW059 no power, can’t find fuse

    Thanks bigsmokepiker (I think)

    Last question … where do I find the pump to test it and does 33Ohm mean it’s broken or good? [/code]

    October 24, 2007 at 10:12 pm #231856
    bigsmokepiker
    Moderator

    Re: Fisher & Paykel MW059 no power, can’t find fuse

    Pump is Under Bowl Of Washer
    Tilt Washer back & it will stick out like the perverable ( On the Front RHS )
    Pump Should read 33 Ohm with multimeter

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.