zanussi washer fs1155 door lock problem

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › zanussi washer fs1155 door lock problem

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • November 28, 2007 at 11:28 am #32570
    jenson
    Participant

    looking at a zanussi fs1155,prod num 914791101/00,any program you select and start,the wash light comes on,the door trys to lock 3 times then end light comes on.tryed door interlock and checked pump,heater,motor,also diagnostic cycle,which lights all the lights in sequence,but when you click the timer round to perform a test function,the door clicks three times as above and end light flashes 4 times,any ideas folks,suspect the module

    November 28, 2007 at 8:36 pm #235654
    aqualectric
    Participant

    Re: zanussi washer fs1155 door lock problem

    Quite probably PCB – try EMW – they have started doing these. Telephone number for reference; (01159) 652118.

    HTH,

    Steve.

    November 30, 2007 at 3:05 pm #235655
    MDE
    Participant

    Had same fault on same Mod. yesterday,track blown on PCB ,block with 1yellow wire 6 red wires second red wire from right, its going to number 3 on door interlock.Dont know if PCB can be fixed.

    Mark.

    December 10, 2007 at 8:18 pm #235656
    lerch
    Participant

    Re: zanussi washer fs1155 door lock problem

    Bit late but on some zanussi machines with the jet system the regen pump will blow the pcb when it fails. so you will need to change both.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.