- This topic has 4 replies, 4 voices, and was last updated 18 years, 4 months ago by
.
-
Posts
-
Model ZWD 14270W error 10.Triple valve ok but does not fill.Spin, pump and dry ok but selecting a wash program gives E 10.
Re: zanussi
Can’t find that model number – ZWD14270W not on TDS. Can you post the PNC number?
Steve.
Re: zanussi
Table of alarm codes
Alarm Possible fault Action/machine status Reset
E11
Tap closed or water pressure too low; Drain tube improperly positioned; Water fill solenoid
valve is faulty; Leaks from water circuit on pressure switch; Pressure switch faulty; Wiring
faulty; PCB faulty.
Cycle is paused with door locked. START/RESET
E12
Tap closed or water pressure too low; Drain tube improperly positioned; Water fill solenoid
valve is faulty; Leaks from water circuit on pressure switch; Pressure switch faulty; Wiring
faulty; PCB faulty.
Cycle is paused with door locked. START/RESET
E13
Drain tube improperly positioned; Water pressure too low;
Water fill solenoid valve is faulty; Water circuit on pressure switch is leaking/clogged; Pressure
switch faulty.
Cycle is paused with door locked. START/RESET8 ALARMS
8.1 Displaying the alarms to the user
The alarms are displayed by the red LED of the START/PAUSE button flashing and simultaneously through the
LCD or Display.
The alarms displayed to the user are listed below:
�� E10 – Water fill difficulty (closed tap)
�� E20 – Drain difficulty (dirty filter)
�� E40 – Door open
only thing i can find. hope this helps.
TELL.
- You must be logged in to reply to this topic.