zanussi auto flashing E90

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › zanussi auto flashing E90

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • December 5, 2007 at 7:04 pm #32767
    monkey
    Participant

    Does anyone know what the error E90 is
    monkey

    December 5, 2007 at 7:06 pm #236329
    eastlmark
    Moderator

    Re: zanussi auto flashing E90

    That is the customer code, need to interrogate the pcb on the test programme to find the actual code.

    December 6, 2007 at 10:32 am #236330
    aqualectric
    Participant

    Re: zanussi auto flashing E90

    Communication fault between user interface and PCB. (fascia PCB and power board). Usually the connections on the fascia are oxidised and just need cleaning.
    Remove the fascia, disconnect the wiring plug, carefully remove the board from the fascia and clean the edge connections. Then refit into fascia and gently pinch the plug with pliers to tighten it before fitting. Refit fascia and all should be OK. If not, check the loom between the fascia and the main PCB. If that’s OK, then it’s PCB failure.

    Hope that helps,

    Steve.

    December 8, 2007 at 1:20 pm #236331
    monkey
    Participant

    Re: zanussi auto flashing E90

    thanks I found the pump was sticking
    monkey

    December 9, 2007 at 1:05 pm #236332
    admin
    Keymaster

    Re: zanussi auto flashing E90

    monkey wrote:thanks I found the pump was sticking
    monkey

    😯 =E90 :hmm: :rotfl:

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.