- This topic has 4 replies, 4 voices, and was last updated 18 years, 4 months ago by
.
-
Posts
-
Hiyas,
I’ve fitted a new PcB to this machine and it isn’t working properly.
When a program is selected the machine starts up but goes straight to the rinse program.
Should there have been a configuration sheet with the pcb? If so, does anyone have one?Thanks in advance for the help.
BrianRe: Bosch WFO2466GB/07
yup there are dip s/w’s that you have to set dependent on the functions, spin speed and brand.
unfortunately I don’t have a coding sheet to hand.
Greg may be able to help you out when he sees this later though.
Re: Bosch WFO2466GB/07
Have you checked to make sure that the selector switch hasn’t gone back into the PCB upside down ? IIRC , the slector on the board will always be set to the 12 o’clock position so if the selector was not at the ‘off’ position when you removed it , its possible that it could have gone on wrong.
If the selector switch is out by 180* , the first position it points to anti-clockwise , 30*C easy care ( 11 o’clock position ) will actually be the rinse programme.
Sorry if you’ve already thought of this 😉
Re: Bosch WFO2466GB/07
Looks like its pre-coded as I cannot see a coding sheet .
Although Im sure superfix is correct as it may have been omitted from the archive as it will be the only one of this range that has never needed coding :con: .
The module you should have received should be p/no 443230 😀Greg
Re: Bosch WFO2466GB/07
OK, thanks for the replies.
I’ll check to see if it’s 180 degrees out but I’m 99.9999{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} sure it isn’t.
I’ll also check to make sure I’ve been sent the correct pcb.
Wouldn’t be the first time it’s been wrong.Thanks
Brian
- You must be logged in to reply to this topic.