hotpoint wf860 stuck

This topic has 4 replies, 4 voices, and was last updated 18 years, 4 months ago by phil59.

Viewing 5 posts - 1 through 5 (of 5 total)

Author

Posts
December 8, 2007 at 6:43 pm #32852

phil59
Participant

hi guys me again
hotpoint wf860 goes through the whole prog until last min showing on display then it just keeps on going
if you quit and put it on spin its ok (any ideas)
thanks in advance

December 8, 2007 at 6:54 pm #236619

johnnyj
Participant

Re: hotpoint wf860 stuck

Heater down to earth or open circuit can cause this fault.

December 8, 2007 at 8:13 pm #236620

billyblue
Participant

Re: hotpoint wf860 stuck

The eeprom needs re-programing.

December 9, 2007 at 6:31 pm #236621

phil59
Participant

Re: hotpoint wf860 stuck

thank guys i will check the heater first

December 9, 2007 at 7:57 pm #236622

kiddo66
Participant

Re: hotpoint wf860 stuck

It could be heater fault or pump fault or motor playing up.On these machines if you get a fill/drain/heat time out the prog will continue to the end but you will get 1 minute showing on the display and as you say it wont spin or end the programme.
Author

Posts

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.