Fisher&Paykel LW085 error code 8

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › Fisher&Paykel LW085 error code 8

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 20, 2007 at 6:05 am #33144
    hignfy
    Participant

    Hi have done the diagnostics and the fourth light from the right is lit up, and I hope I am reading the error code correctly.

    Machine stopped mid-cycle, beeping continuously.When attempted to restart it would only fill or empty in short bursts rather than continuously and I cannot get it to spin.

    Can you possibly tell me what the error code means?

    Thanks 🙁

    December 20, 2007 at 11:30 am #237592
    Penguin45
    Participant

    Re: Fisher&Paykel LW085 error code 8

    Hmm – supposed to be a fault with the display module; however, it’s only applicable to phase one machines – yours is a phase four.

    Anyone else able to add anything?

    Penguin45.

    December 21, 2007 at 12:02 am #237593
    bigsmokepiker
    Moderator

    Re: Fisher&Paykel LW085 error code 8

    Typical things to look for Out balance microswitch corroded terminals Etc
    Rotor sensor /Numerous threads on this Problem
    Washer Must pump All the Water before it goes on to Spin
    Check pump for blockages Or Over heating

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.