fdw80p hotpoint dishwasher.

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › fdw80p hotpoint dishwasher.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • January 5, 2008 at 1:26 pm #33417
    bzz67
    Participant

    got one of these in for repair. fills to level, starts circulating & heating ok.
    after a short time the circ pump stops but the heater stays on, after 30 seconds or so the circ pump starts back up then stops again & so on.
    as the water in the heater has no movement at times it boils.
    power to the the motor is cut, there are no breaks in wires.
    could someone confirm that this is a control board fault.
    a part number would be usefull as there apears to be two possibles.
    serial number is 31712648

    January 5, 2008 at 3:31 pm #238556
    Penguin45
    Participant

    Re: fdw80p hotpoint dishwasher.

    PCB always a good bet with these, might be tempted tp see if there’s a safety cut-out in the motor winding though.

    Chris.

    January 6, 2008 at 8:25 pm #238557
    kiddo66
    Participant

    Re: fdw80p hotpoint dishwasher.

    I have had a few of these motors seize after washing for a while,you would be able to tell as the motor gets a tad hot.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.