Hotpoint BF162 not working

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Hotpoint BF162 not working

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • January 14, 2008 at 3:33 pm #33675
    the_big_1
    Participant

    Dear All,

    My built in dishwasher allows water into the system and fills the filter area at the base. It then flashes the second light and empties the water. I removed the electrical valve from the main inlet and tested, seemed ok, removed the electrical valve to the filter and tested, seemed ok. Then powered the pump and that seemed ok too, any ideas?

    January 14, 2008 at 8:25 pm #239554
    the_big_1
    Participant

    Re: Hotpoint BF162 not working

    Update:

    I just measured the resistance on the heater and it was completly open circuit so order a new one.
    Would this cause the same fault?
    I tested the switch relay that is for detecting sum pressure and it tests ok.

    Any ideas if it could be the heater or could it be that for some reason there isnt enough pressure in the sump to switch the pressure relay?

    January 14, 2008 at 10:42 pm #239555
    iadom
    Moderator

    Re: Hotpoint BF162 not working

    The error code you report is supposed to signify a fill valve problem, however the heaters are very prone to failure on these as are the electronics, it is not uncommon to get spurious error messages. The lights for heater failure should be either 4 or 2+4.

    Changing the faulty heater would be the first logical step.

    Jim.

    January 15, 2008 at 7:30 am #239556
    the_big_1
    Participant

    Re: Hotpoint BF162 not working

    When I change the heater and if it doesnt fix the problem, I am guessing its the electronics.
    Both the solenoid valves work and water gets to the sump no problem. If the pressuer relay is then operated and its tested ok, pump is working ok then I presume there is only the electronics left?
    If so, what are the chances of getting the spare?

    January 15, 2008 at 9:35 am #239557
    iadom
    Moderator

    Re: Hotpoint BF162 not working

    All parts are readily available and unlike the Indesit washing machine PCB’s the dishwasher ones are not expensive.

    Jim.

    January 15, 2008 at 9:38 am #239558
    the_big_1
    Participant

    Re: Hotpoint BF162 not working

    Hi,

    where would be a good place to try and get a pcb from?

    January 15, 2008 at 9:52 am #239559
    iadom
    Moderator

    Re: Hotpoint BF162 not working

    spares@ukwhitegoods.co.uk 😉

    Your machine is actually a BFI62, just checked on the module for that one and unfortunately it is a little more expensive than the BFI620 module.

    An e-mail to the above should get you price inc shipping etc.

    Jim.

    January 17, 2008 at 7:36 am #239560
    the_big_1
    Participant

    Re: Hotpoint BF162 not working

    Hi all,

    Replaced heater and it seems to be working now. Even though the fault light indicated water in issue.
    Can anyone tell me approx how long the dishwasher should run for on the cycle that is second from the right?
    It says in the manual that it does two pre-wash cycles then two heat cycles.

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.