Hotpoint WD420

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WD420

Viewing 10 posts - 1 through 10 (of 10 total)
  • Author
    Posts
  • January 28, 2008 at 4:41 pm #34132
    DDDave
    Participant

    Hi Guys, Its my first time posting here after browsing for months.
    I cant find this fault listed in the fault code section. On the above machine there is a vertical row of lights and switchs on the lhs. From the top lights 3 and 4 come on seconds after starting the machine. Any advice would be appreciated.
    Thanks
    Dave

    January 28, 2008 at 4:51 pm #241396
    loopey
    Participant

    Re: Hotpoint WD420

    wash thermister open/short circuit , check connections and thermister ..

    🙂

    January 28, 2008 at 4:57 pm #241397
    DDDave
    Participant

    Re: Hotpoint WD420

    loopey wrote:wash thermister open/short circuit , check connections and thermister ..

    🙂
    Thank you loopey.
    I will give it a try.
    Dave

    January 28, 2008 at 6:27 pm #241398
    iadom
    Moderator

    Re: Hotpoint WD420

    DDDave wrote:
    I cant find this fault listed in the fault code section.

    They are there, page four of the Known Error Codes thread. 🙂

    Jim.

    January 28, 2008 at 8:14 pm #241399
    DDDave
    Participant

    Re: Hotpoint WD420

    iadom wrote:

    DDDave wrote:

    I cant find this fault listed in the fault code section.

    They are there, page four of the Known Error Codes thread. 🙂

    Jim.
    Hi Jim.
    That gives me fault code O3 – F03….OFF, OFF, Flash, Flash, OFF.
    Can you tell me where the list is to decode the fault code.
    Thanks
    Dave

    January 28, 2008 at 8:36 pm #241400
    iadom
    Moderator

    Re: Hotpoint WD420

    It tells you at the top of that post.

    These can be read in conjunction with Dave Conway’s post on page 3 of this thread regarding WIDL codes.

    January 28, 2008 at 9:42 pm #241401
    DDDave
    Participant

    Re: Hotpoint WD420

    iadom wrote:It tells you at the top of that post.

    These can be read in conjunction with Dave Conway’s post on page 3 of this thread regarding WIDL codes.

    Doh ! Got it.
    Thanks again guys
    Dave

    February 5, 2008 at 4:27 pm #241402
    DDDave
    Participant

    Re: Hotpoint WD420

    I am still having problems with this machine. I have replaced the element & thermister but the same fault code still comes up. I have also tested the wiring from the board to the thermister , its ok. Is there a reset on the board ?? Any ideas please.

    February 5, 2008 at 4:53 pm #241403
    iadom
    Moderator

    Re: Hotpoint WD420

    No reset, these Indesit boards are very unreliable and are often as not the source of the fault. 😥

    Jim.

    February 6, 2008 at 12:17 am #241404
    DDDave
    Participant

    Re: Hotpoint WD420

    Ok , thanks Jim.

  • Author
    Posts
Viewing 10 posts - 1 through 10 (of 10 total)
  • You must be logged in to reply to this topic.