Hotpoint TDC32

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint TDC32

  • This topic has 4 replies, 4 voices, and was last updated 18 years ago by PGS.
Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • March 20, 2008 at 4:26 pm #35445
    PGS
    Participant

    This M/C heats for about 5/10 mins then cuts out and the dryer light goes off at same time as if it is cycling, before i strip it down could it just be the front stat cheers paul.

    March 20, 2008 at 4:39 pm #246520
    iadom
    Moderator

    Re: Hotpoint TDC32

    Could be, could also be rear stat, timer or even float switch. Front stat pulls down into to drum without any strip down required, often shows signs of burning if it is at fault.

    If it is any help I can send you wiring diagrams for TDC30, uses exactly same timer.

    Jim.

    March 20, 2008 at 5:25 pm #246521
    hotpnt
    Participant

    Re: Hotpoint TDC32

    hi, when you say it cust out, is the whole machine stopping or just the heat? if its the whole machine it will be the relay up top

    March 20, 2008 at 5:27 pm #246522
    PGS
    Participant

    Re: Hotpoint TDC32

    Just the heat, have checked rear stats and they are 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} ok.

    March 21, 2008 at 12:40 am #246523
    bubs
    Participant

    Re: Hotpoint TDC32

    Its normally a timer fault
    Graeme

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.