Fisher & Paykel 913T Dishwasher not hot filling

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › Fisher & Paykel 913T Dishwasher not hot filling

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • March 26, 2008 at 4:24 am #35534
    Flyer
    Participant

    After the cold rinse cycle the hot valve isn’t opening to fill with hot water. We’ve checked out the resistance of both valves, readings 3.7K and checked all the wiring. There is no sign of burning on either the controller PCB or the power board. Any suggestions where to go next? A diagnostic routine would be helpful.

    March 26, 2008 at 4:28 am #246985
    admin
    Keymaster

    Re: Fisher & Paykel 913T Dishwasher not hot filling

    Hi

    Penguin45 will most likely reply later today when he comes back on line as he has the relivent knoweldge.

    Bryan

    March 26, 2008 at 6:25 am #246986
    bigsmokepiker
    Moderator

    Re: Fisher & Paykel 913T Dishwasher not hot filling

    Suggest you try & test if any power coming out of Bottom PCB To Hot Valve (yellow wire goes from hot valve to PCBI)f Not Youll might Need Bottom PCB
    If That is the Case Suggest using dishwasher on cold fill option only
    The Dishwasher will heat its own Water when required anyway

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.