- This topic has 7 replies, 2 voices, and was last updated 18 years ago by
.
-
Posts
-
Hi all ive looked at the codes for al10 which this machine is bringing up heating etc,but the heater is ok and power getting to heater.As far as i can gather it is getting to hot as customer said it smelled really hot do i need a new board or can the temperature sensor be changed. Any info would help.thanks.
Re: hotpoint fdw80p
NTC is connected to PCB direct. The NTC can come adrift of it mounting inside the door.
Jim.
Re: hotpoint fdw80p
Yes looked at that and was a bit loose tighted it but customer just phoned and said still doing it .
Re: hotpoint fdw80p
I have changed quite a few boards on these, all for heater related faults up to now.
Jim.
Re: hotpoint fdw80p
ok sounds like the board then ,i sold this to them second hand a few months back for £100 so it aint gona be worth fixing. Its a pain as i only went there in the first place to change the top spray arm fixing nut as i did that it then melted a hole in the drain hose so changed that then this happened,what a pain.
Re: hotpoint fdw80p
Boards are not that dear on these, list price is only £25.00 ex vat before any discount.
jim.
Re: hotpoint fdw80p
oh i see i had a look on connect and was not vry clear do you have a part number ,serial number is 510111037 (37331870000) any info will help cheers.
- You must be logged in to reply to this topic.