candy cond t/drier, not starting. CDE105 80

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › candy cond t/drier, not starting. CDE105 80

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • April 14, 2008 at 7:41 pm #36009
    TELL
    Participant

    have checked the m/c for power, there is 240v going to the module, and switches etc, checked the display board its ok. can anyboby confirm, is it the module. had a look for bad joints, or anything blown, nowt to be seen.
    1st one ive been to, and can’t see any thermal cut out etc.
    TELL..

    April 14, 2008 at 7:43 pm #249129
    helo_75
    Participant

    check the float switch, have you?

    April 14, 2008 at 7:49 pm #249130
    Flyman
    Participant

    Re: candy cond t/drier, not starting. CDE105 80

    Hello Terry. Thermal fuse is mounted inside the element at one side.

    April 14, 2008 at 9:15 pm #249131
    TELL
    Participant

    Re: candy cond t/drier, not starting. CDE105 80

    checked float switch, but there is no power, or lights on the display board, or indication of tank to be emptied ?.
    hi jim.
    never checked the element toc, did not know their was one, but would this shut down display, and functions on all of the drier. as i said i have 240v coming into the module, and power to door m/switch.

    April 14, 2008 at 9:29 pm #249132
    helo_75
    Participant

    is that the model where the start button breaks behind the bezel?

    try taking the board off, and check where the button activates the pcb?>

    April 15, 2008 at 10:07 am #249133
    TELL
    Participant

    Re: candy cond t/drier, not starting. CDE105 80

    i have taken off the display board and cheked the start switch, and button they are ok. metered the switchs and i’m getting a reading through them.
    TELL..

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.