Tecnik TKD795

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Tecnik TKD795

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • April 18, 2008 at 2:53 pm #36126
    zoot_horn_rollo
    Participant

    Hello, first time caller here…

    My Tecnik dishwasher won’t stop trying to drain when I open the front. I have tried resetting by pushing the appropriate buttons as per the user manual but this doesn’t have any effect.

    I have switched off at the mains but when Is witch the power on it keeps continuining to drain and then I get a inlet water fault showing on the panel.

    Any ideas?

    April 18, 2008 at 8:03 pm #249660
    Penguin45
    Participant

    Re: Tecnik TKD795

    Base underneath will be flooded, flood protection activated so drain pump running and over-riding any programming. Drain the base, if it does it again it’s “Hunt the Leak” time.

    Power off first.

    Penguin45.

    May 4, 2008 at 1:34 pm #249661
    zoot_horn_rollo
    Participant

    Re: Tecnik TKD795

    Thanks for that tip, which I will try later today.

    Would the programme overriding include continue to try to drain when the front door is opened and when it normally cuts out?

    May 4, 2008 at 1:53 pm #249662
    Penguin45
    Participant

    Re: Tecnik TKD795

    Yup.

    Penguin45.

    May 7, 2008 at 3:20 pm #249663
    zoot_horn_rollo
    Participant

    Re: Tecnik TKD795

    Ok, leaving the door open for a while seems to clear the problem and it switches itself off. However, on restarting the programme the low water error light comes on and after a while the pump restarts and goes on for a while again.

    Is this indicative of a water leak in the base?

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.