- This topic has 6 replies, 3 voices, and was last updated 17 years, 11 months ago by
.
-
Posts
-
This m/c will wash ok, but will only spin slow – assuming it’s the clutch how can you tell & how do you get to it?
The gearbox shaft will turn by hand in both directions – is it still the consensus of opinion that this could be a gearbox problem?
Brian.
Re: Whirlpool t/l 3RLBR8543JQ0
In spin mode the agitator is disengaged and is free to turn by hand. Otherwise the machine would try to agitate during spin and rip the clothes.
You might find THIS interesting.
Re: Whirlpool t/l 3RLBR8543JQ0
spanner51 wrote:In spin mode the agitator is disengaged and is free to turn by hand. Otherwise the machine would try to agitate during spin and rip the clothes.
You might find THIS interesting.
So if i put the machine in wash mode for a couple of minutes then unplug it, if the agitator shaft can be turned by hand it’s duff – is this a defining test for the gearbox of is there another?
Brian.
Re: Whirlpool t/l 3RLBR8543JQ0
senseib wrote:
So if i put the machine in wash mode for a couple of minutes then unplug it, if the agitator shaft can be turned by hand it’s duff
Yes
What I usually do is :-
Fill machine with water and let it agitate for a few seconds. Switch off, put my hands in the water, grab hold of the agitator and you should not be able to move it.
Switch on to spin, let it empty, wait for the pause and the gearbox will clunk in to spin mode. Let it spin for a few seconds. Switch off, grab hold of the agitator and it should turn freely.
If you are getting slow spin, make absolutly sure that it is pumping fast enough, and with no blockages. If it is pumping OK then I would suspect the drive clutch. hth
Re: Whirlpool t/l 3RLBR8543JQ0
Thanks spanner51, what sort of a job is it to replace the drive clutch?
p.s Any chance of part numbers for drive clutch & brake lever?
Brian.
- You must be logged in to reply to this topic.