Replacing thermostatic probe on Bosch HBN7050GB/01

Home › Forums › Public Support Forums › Help And Support › Cooker And Oven Forum › Replacing thermostatic probe on Bosch HBN7050GB/01

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • April 24, 2008 at 5:26 pm #36267
    RavsDad
    Participant

    Hi people,

    On an earlier thread Penguin45 advised a replacement t’stat to cure element blowing problems.

    I’ve now received the replacement part no:489378 ordered from ukwhitegoods and I have a question. The new part differs cosmetically from the original – it’s half as tall and, looking from the back the two male terminals are located at “ten to four” instead of side by side at the top as on the taller original.

    There doesn’t seem to be a way to identify which should go on which. Does it matter?

    Your help would be much appreciated.

    April 24, 2008 at 5:44 pm #250268
    admin
    Keymaster

    Re: Replacing thermostatic probe on Bosch HBN7050GB/01

    Hi

    It doesnt matter which of the 2 wires go onto what terminal if there is only 2 wires,the thermostats can change cosmeticly quite regulary.

    Bryan

    April 24, 2008 at 7:04 pm #250269
    RavsDad
    Participant

    Re: Replacing thermostatic probe on Bosch HBN7050GB/01

    Thanks for the quick reply Bryan.

    Job done and oven element now switches on and off as it should. 😀

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.