smeg wdi 16ba

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › smeg wdi 16ba

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • April 30, 2008 at 1:00 pm #36408
    simonb
    Participant

    fault e14 checked cutout on dryer on righthand side and is closed circuit ok
    theres a thermister over to left hand side located inside rubber manifold to dryer inlet, check for circuit and seems ok, not too sure about in range ohms?
    normally doesent e14 mean thermistor fault?
    can they go out of range and not just open?
    does just changing it rectify the problem in all cases?


    apart from that, machine works fine, fills spins,drains etc.
    thanks
    simon

    April 30, 2008 at 3:47 pm #250888
    eastlmark
    Moderator

    Re: smeg wdi 16ba

    We always stick a new ntc in the rubber belloes at the front of the machine for a F14 fault, although have a tug at the wiring to it as they can break at the plug. its a common problem on these.

    April 30, 2008 at 11:08 pm #250889
    simonb
    Participant

    Re: smeg wdi 16ba

    Great ill try one, iv tryed to find part number with no joy as yet but will try search on google tomorow.

    thanks simob

    April 30, 2008 at 11:26 pm #250890
    Penguin45
    Participant

    Re: smeg wdi 16ba

    817870012

    Chris.

    April 30, 2008 at 11:36 pm #250891
    Lawrence
    Participant

    Re: smeg wdi 16ba

    look underneath tub for another NTC may have a broken wire on block
    Lawrence

    May 1, 2008 at 5:23 pm #250892
    simonb
    Participant

    Re: smeg wdi 16ba

    Thanks for part number chris!

    thanks gang

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.