Fisher & Paykel MW 053-U

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › Fisher & Paykel MW 053-U

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • May 23, 2008 at 1:49 am #36905
    PAJAMAHOJO
    Participant

    I have just replaced the water mixer Motor Controller.

    I have installed the new motor. The machine turns on ok from the power up button, how ever when the Start button is pushed the board shows a

    Fualt #9 …This is worked out using your sticky

    I have tried to set the size using available information. But I am having no luck

    I have run through the diagnostic process and it still indicates a code #9

    Out Back Australia Needs Your Help Please

    May 23, 2008 at 11:43 am #252748
    Penguin45
    Participant

    Re: Fisher & Paykel MW 053-U

    PAJAMAHOJO wrote:I have had some minor success from F&P services desk.

    After replacing the Motor Module I was instructed to… Press and Hold the Start/Pause Button and Press the Power Button.

    This reset the new module and allowed it to start working. How ever I had to set the size.

    Setting the size was done while in the reset mode and is the same selection Choices as all models.

    To activate this models Diagnostic push and hold the Temp Down Button and push the Power Button, hold until the LED’S change.

    Also don’t discount that the problem could be as simple as the Hot and Cold valves. I suggest that disregarded machines are worth salvaging and using their parts to test on your machine.

    May 24, 2008 at 2:39 am #252749
    PAJAMAHOJO
    Participant

    Re: Fisher & Paykel MW 053-U

    I’m sorry I don’t understand what is ment by “Unplugged it”

    May 24, 2008 at 7:31 am #252750
    Penguin45
    Participant

    Re: Fisher & Paykel MW 053-U

    It’s a signature, saves me typing it out every time I post. No comment intended, just moved your post to keep the threads continuity.

    Regards,
    Penguin45.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.