- This topic has 1 reply, 2 voices, and was last updated 17 years, 10 months ago by
.
-
Posts
-
Hi, i need help with my washing machine, I have tried to run the diagnostics but not sure is it right. Here what i did:
– hold ‘wash temp down’ and press ‘power’
– i didn’t get any beeps
– diagnostics lit: 00010100
– press ‘Advance’ once then press ‘spin’ numbers of time, but no lit on neither ‘hold’ or ‘slow’
– diagnostics lit still the same: 00010100
– sometime the 6th led also lit up for few seconds (00110100).Does anyone know what’s going on?
any suggestion?
Thanks!Re: F&P MW051-U stop during spin cycle
Depending on which way round the code is read, it’s either a problem between the computer boards or a tub disengagement fault. If it was meant to be going into spin, this is perhaps more likely. It can be caused by excess soap suds giving a false reading on the water level control. Try doing a couple of deep rinses and see if it clears as a starting point.
Penguin45.
- You must be logged in to reply to this topic.