F&P MW051-U stop during spin cycle

[yanga]

Hi, i need help with my washing machine, I have tried to run the diagnostics but not sure is it right. Here what i did:

– hold ‘wash temp down’ and press ‘power’
– i didn’t get any beeps
– diagnostics lit: 00010100
– press ‘Advance’ once then press ‘spin’ numbers of time, but no lit on neither ‘hold’ or ‘slow’
– diagnostics lit still the same: 00010100
– sometime the 6th led also lit up for few seconds (00110100).

Does anyone know what’s going on?
any suggestion?
Thanks!

[Penguin45]

Re: F&P MW051-U stop during spin cycle

Depending on which way round the code is read, it’s either a problem between the computer boards or a tub disengagement fault. If it was meant to be going into spin, this is perhaps more likely. It can be caused by excess soap suds giving a false reading on the water level control. Try doing a couple of deep rinses and see if it clears as a starting point.

Penguin45.

[Author]

Posts