hotpoint ctd85 fault

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › hotpoint ctd85 fault

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • May 28, 2008 at 12:50 pm #37010
    razor
    Participant

    Hi all , got a hotpoint ctd85 eith a F15 fault , F15 – Dynamic heater relay with contact welded closed

    is this the module ??

    Thanks all

    May 28, 2008 at 3:25 pm #253123
    iadom
    Moderator

    Re: hotpoint ctd85 fault

    The full list of possible causes from the error codes thread.
    …………………………………………………………………………..

    F15 Dynamic (PD) heater Relay
    with NA/NC contact welded
    closed.
    – Verify efficiency of contact J4;
    – Verify at room temperature (20°C) on the J4 connector if the
    resistance between Pin 1 and 2 is 48 Ω;
    – Verify continuity between wiring between J4 and Static Heater;
    – Replace Heater;
    – Replace main board.

    ……………………………………………………………………………

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.