Fisher & Paykel Excellance 7.5 Problem

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › Fisher & Paykel Excellance 7.5 Problem

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • May 30, 2008 at 11:33 am #37051
    tobor
    Participant

    My F & P 7.5 Washing Macine will wash but wont go into spin mode.
    Does a few half turns then stops and beeps
    Error code is 11

    Can you help?

    Tobor

    May 31, 2008 at 12:42 am #253292
    Penguin45
    Participant

    Re: Fisher & Paykel Excellance 7.5 Problem

    11 is water level sensor not working properly. Standard cause is water in the pressure hose – drain the machine completely and blow through to clear any debris. Switch unit itself is integral with the pcb, so if faulty, repacement pcb is required.

    You appear to own three washing machines?

    Penguin45.

    May 31, 2008 at 8:55 am #253293
    tobor
    Participant

    Re: Fisher & Paykel Excellance 7.5 Problem

    Thanks Penguin

    Your suggestion works and it now spins, the only problem that it now goes out of balance really easily is there any reason for this?
    By the way, it is actually my sisters washing machine.
    She has had it for ten years and can’t bear to part with it.
    I have been told that women get attached to washing machines the same way men get attached to their cars.

    Thanks
    Tobor

    May 31, 2008 at 9:24 am #253294
    Penguin45
    Participant

    Re: Fisher & Paykel Excellance 7.5 Problem

    There should be a tub bias spring fitted in the front left corner, effectively pulling the tub away from the OOB lever. When set up correctly, looking into the tub, the front lip should be just tucking under the edge of the top deck.

    Penguin45.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.