MW511 – Looping cycle won’t turn off!

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › MW511 – Looping cycle won’t turn off!

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • June 2, 2008 at 1:04 am #37090
    Scoobydoo28
    Participant

    Hi, we have a MW511 Fisher and paykel washer, a couple of weeks ago it started looping the cycle continuously. (ie, it would finish spin and then start the cycle again). After reading this forum I found the problem was that it was set on loop cycle. I reset it and all was well with the world.

    Then it started doing it again. So I tried resetting it again, but it doesn’t work and all the lights flash when the machine is turned off. (Only the last 3 flash if the loop function is on). I’ve tried turning it off for a while to reset it but makes no difference.

    Also, there are no error codes coming up. Any ideas?

    Thanks
    Mike

    June 2, 2008 at 8:09 am #253487
    kiwireeferman
    Participant

    Re: MW511 – Looping cycle won’t turn off!

    If you have turned off the continuous run cycle then I would think the controller has crashed.
    The display board is dumb so should not be the problem.

    June 2, 2008 at 9:16 am #253488
    Scoobydoo28
    Participant

    Re: MW511 – Looping cycle won’t turn off!

    I’m guessing that ‘the controller has crashed’ loosely translates into ‘call the repairman’, or ‘push it off a cliff’ then?

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.