Hotpoint WF541 module clicking pump and motor stop/starts

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WF541 module clicking pump and motor stop/starts

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • June 9, 2008 at 5:52 pm #37275
    DPDOM
    Participant

    Hi Chaps
    Hotpoint Wf541 on spin program the pump starts and stops rapidly and so does the motor. The module relays are clicking every few seconds.
    Today I fitted a module(EMW) the same thing happened.
    Found a bad earth inside molded plug so replaced but still the same.
    The motor will spin after a while but a bit rough.
    Disconnecting the pump has no effect on the relays clicking.
    No fault codes shown.
    Help before I hit the Bottle.

    Dave

    June 10, 2008 at 7:38 pm #254212
    admin
    Keymaster

    Try again with other motor… I have had once this fault but also in washing program and old motor damaged also new module(motor relays).

    June 10, 2008 at 7:52 pm #254213
    DPDOM
    Participant

    Re: Hotpoint WF541 module clicking pump and motor stop/start

    Thanks Baron.
    Yes it does it on the wash cycle aswell and relays don’t click while filling.
    so yes it looks like a motor fault even though my meter says all is ok.
    suspect a new machine on its way.

    Thanks

    David

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.