hotpoint WF440 doesn’t spin at the end of the program

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › hotpoint WF440 doesn’t spin at the end of the program

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • June 17, 2008 at 9:22 pm #37448
    nelson
    Participant

    I went to have a look at this one today customer reports that the machine runs the program all the way through but doesn’t spin, however when the fast spin or slow spin program is selected it spins fine.

    I thought maybe obstruction in the pump or sump stopping the machine spinning but it was as clean as a whistle. I checked the brushes they looked as good as new.

    Also the customer said that at the end of the wash only the door lock / pre-wash/ wash/ rinse & spin lights were illuminated and the final spin light was not.

    Any ideas?

    June 17, 2008 at 10:30 pm #255166
    aqualectric
    Participant

    Re: hotpoint WF440 doesn’t spin at the end of the program

    The pressure switch used on this machine is liable to stick on full or empty – this can throw up the fault code on the switch LED’s. The vertical LED’s are the fault code. The top one is no. 1: down to no. 5. The fault code should be in the “Known Fault Codes” thread at the top of this forum.

    HTH,

    Steve.

    June 18, 2008 at 5:30 am #255167
    nelson
    Participant

    Re: hotpoint WF440 doesn’t spin at the end of the program

    Thanks for that steve, the customer said that none of the vertical leds were illuminated, only the horizontal leds with the exception of final spin???

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.