Bosch WFT2800GB/13

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch WFT2800GB/13

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • June 18, 2008 at 3:59 pm #37468
    S1MON
    Participant

    Bosch WFT2800GB/13

    Washer drier tripping over heat out on drier ducting found OC valve replaced this all seemed to work fine. Gone back today same agin but ive found the m/c with only fill and drain on setting 3 of the drying cycle.

    There is no valve or drain pump action on settings 1 and 2?

    Apart from the pcb anyhting else can cause this. It runs completely fine on setting 3

    June 18, 2008 at 8:14 pm #255223
    Penguin45
    Participant

    Re: Bosch WFT2800GB/13

    Doesn’t it have to get up to a pre-set temperature before the valve and the pump cut in?

    Chris.

    June 19, 2008 at 5:04 pm #255224
    S1MON
    Participant

    not sure on program 3 it comes on almost staright away and not at all on 1 and 2?

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.