wf0285sgb

This topic has 5 replies, 3 voices, and was last updated 17 years, 9 months ago by timjam.

Viewing 6 posts - 1 through 6 (of 6 total)

Author

Posts
June 25, 2008 at 5:55 pm #37643

timjam
Participant

Hi , been out to this and replaced worn out carbons, now when on spin prog, it only gets to 6 mins on display and goes to end without giving full spin!!! any ideas ???? 😯

June 25, 2008 at 6:16 pm #255911

Penguin45
Participant

Re: wf0285sgb

Armature’s on its way out.

Chris.

June 25, 2008 at 6:43 pm #255912

timjam
Participant

Re: wf0285sgb

cheers chris, is there an armature for it or is it a case of replacing motor?

June 25, 2008 at 6:45 pm #255913

Penguin45
Participant

Re: wf0285sgb

Motor only 🙁 .

Chris.

June 25, 2008 at 6:45 pm #255914

timjam
Participant

Re: wf0285sgb

ok thanks 😀 😀

June 25, 2008 at 7:19 pm #255915

timdowning
Participant

Re: wf0285sgb

This is quite a common occurance when you change the brushes on this range. Don’t be to hasty in writing off the machine. Tell the customer to do at least 4 empty cycles. This will hopefully allow the new brushes to bed in.
Author

Posts

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.