wf0285sgb

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › wf0285sgb

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • June 25, 2008 at 5:55 pm #37643
    timjam
    Participant

    Hi , been out to this and replaced worn out carbons, now when on spin prog, it only gets to 6 mins on display and goes to end without giving full spin!!! any ideas ???? 😯

    June 25, 2008 at 6:16 pm #255911
    Penguin45
    Participant

    Re: wf0285sgb

    Armature’s on its way out.

    Chris.

    June 25, 2008 at 6:43 pm #255912
    timjam
    Participant

    Re: wf0285sgb

    cheers chris, is there an armature for it or is it a case of replacing motor?

    June 25, 2008 at 6:45 pm #255913
    Penguin45
    Participant

    Re: wf0285sgb

    Motor only 🙁 .

    Chris.

    June 25, 2008 at 6:45 pm #255914
    timjam
    Participant

    Re: wf0285sgb

    ok thanks 😀 😀

    June 25, 2008 at 7:19 pm #255915
    timdowning
    Participant

    Re: wf0285sgb

    This is quite a common occurance when you change the brushes on this range. Don’t be to hasty in writing off the machine. Tell the customer to do at least 4 empty cycles. This will hopefully allow the new brushes to bed in.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.