Big Bosch

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Big Bosch

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • June 26, 2008 at 9:54 am #37661
    iadom
    Moderator

    Part tech & part spares query.

    Model WBB24759GB-01

    Not seen it yet, in residential home, hole in door seal.

    Tech question, how difficult is a door seal change on one of these ?

    Parts query, two different seals shown, 243834 around £68 and 445193 at £38.

    Would I be correct in thinking that the more expensive one is either butyl or EPDM or some other grease/fat/bleach resistant rubber?

    Jim.

    June 26, 2008 at 11:00 am #255970
    Penguin45
    Participant

    Re: Big Bosch

    Hi Jim,
    Front comes off (bottom screws are at the side) and a clamp band. Weights in two halves, so band is accessible.

    No idea about the door seals.

    Chris.

    June 26, 2008 at 11:25 am #255971
    don
    Moderator

    Re: Big Bosch

    Hi Jim

    Info from e shop on those two part numbers

    Bosch E Shop wrote: Part no. 445193 Substitute part no. 667489 Boot gasket Door seal, washer, w/o flushing hose port

    Part no. 243834 Substitute part no. 246270 Boot gasket Gasket holder, white, with boot & labels. 68.29 GBP

    HTH

    Don

    June 26, 2008 at 2:16 pm #255972
    iadom
    Moderator

    Re: Big Bosch

    Thanks Don, it looks as though I will have to pay a visit, just in case this one has a ‘flushing hose port’ :rolls:

    Thanks Chris as well, 😉

    Jim.

    June 26, 2008 at 4:33 pm #255973
    gegsy
    Participant

    Re: Big Bosch

    Logixx 9, nice piece of kit 😀

    You have mails Jim

    Greg

    June 26, 2008 at 4:41 pm #255974
    iadom
    Moderator

    Re: Big Bosch

    Thanks Greg, is there any way of knowing which of the two seals it might need without going to have a look?

    Jim.

    June 26, 2008 at 4:44 pm #255975
    gegsy
    Participant

    Re: Big Bosch

    Only showing one here 😕 246270 £58.12 + the usual

    Greg

    June 26, 2008 at 4:53 pm #255976
    gegsy
    Participant

    Re: Big Bosch

    Update 😀

    445193 which is part change now to 667489 and used FD8505 & thereafter 8)

    Greg

    July 29, 2008 at 4:16 pm #255977
    iadom
    Moderator

    Re: Big Bosch

    Did this seal a couple of weeks ago, a bit of a struggle if you change the whole kit with new plastic seal surround.

    Now have a query on another one. Customer( on the phone) is complaining of poor spin.

    I have got them to check the filter, nothing much in there. Now trying it without a load to eliminate possible OOB.

    Any other possibles, will apparently rotate but not pick up speed to spin.

    Jim.

  • Author
    Posts
Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.