Fisher Paykel GW609 fault

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › Fisher Paykel GW609 fault

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • July 2, 2008 at 10:00 am #37807
    Elevatorman
    Participant

    My dear old GW609 has a problem.

    It only works for a full cycle intermittently. When it faults, it is usually just starting to fill on the rinse cycle or just finishing draining before the spin cycle.

    When it faults, the machine beeps forever and the following LEDs are on:

    01000001

    I went into the diagnostic mode, and the same LEDs come on, which I think is fault 65.

    I’ve tried searching the forums for this error but have come up blank.

    Any ideas?

    July 2, 2008 at 6:53 pm #256439
    Penguin45
    Participant

    Re: Fisher Paykel GW609 fault

    That’s because it’s 130 – rotor position sensor error. Loads of posts about RPSs…….. 😀

    Penguin45.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.