tricity caw1010

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › tricity caw1010

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • July 3, 2008 at 8:16 pm #37862
    deltra
    Participant

    hi, no wash action,then goes into high speed spin for 1sec,flash from motor and stops.wait 1 minute and does same again :rolls: me thinks tacho,or windings fault ❓ ordered a new motor and bu{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d}{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d}$r me same fault ❓ checked wiring harness etc ,no faults, no burn marks on module. whats the odds of the new one having same fault as the old one ❓ ❓ although new one does look like a recon(zn42101..mpart).any suggestions ❓

    July 3, 2008 at 9:15 pm #256821
    leavemetogetonwithit
    Participant

    Re: tricity caw1010

    Send module to EMW for testing.
    Mike.

    July 3, 2008 at 11:33 pm #256822
    Penguin45
    Participant

    Re: tricity caw1010

    Triac failure on board is a good bet. You can check continuity to the motor from the board end just in case.

    Penguin45.

    July 4, 2008 at 12:34 am #256823
    deltra
    Participant

    Re: tricity caw1010

    faulty board wouldnt make motorspark and trip rcd ,would it ❓

    July 4, 2008 at 2:34 pm #256824
    leavemetogetonwithit
    Participant

    Re: tricity caw1010

    deltra wrote:trip rcd ❓

    You didn’t mention that in your opener.
    If motor zips into spin due to fault in tacho/wiring/control circuit it is conceivable that that could blow the trip sometimes especially with a load in.
    Mike.

    July 12, 2008 at 9:21 pm #256825
    deltra
    Participant

    Re: tricity caw1010

    hi guys, just to let you know that you were right 😳 got a timer/module from emw. machine now running like a new un 😉

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.