tricity caw1010

[deltra]

hi, no wash action,then goes into high speed spin for 1sec,flash from motor and stops.wait 1 minute and does same again :rolls: me thinks tacho,or windings fault ❓ ordered a new motor and bu{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d}{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d}$r me same fault ❓ checked wiring harness etc ,no faults, no burn marks on module. whats the odds of the new one having same fault as the old one ❓ ❓ although new one does look like a recon(zn42101..mpart).any suggestions ❓

[leavemetogetonwithit]

Re: tricity caw1010

Send module to EMW for testing.
Mike.

[Penguin45]

Re: tricity caw1010

Triac failure on board is a good bet. You can check continuity to the motor from the board end just in case.

Penguin45.

[deltra]

Re: tricity caw1010

faulty board wouldnt make motorspark and trip rcd ,would it ❓

[leavemetogetonwithit]

Re: tricity caw1010

deltra wrote:trip rcd ❓

You didn’t mention that in your opener.
If motor zips into spin due to fault in tacho/wiring/control circuit it is conceivable that that could blow the trip sometimes especially with a load in.
Mike.

[deltra]

Re: tricity caw1010

hi guys, just to let you know that you were right 😳 got a timer/module from emw. machine now running like a new un 😉

[Author]

Posts