AEG Pryo Oven

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › AEG Pryo Oven

Viewing 1 post (of 1 total)
  • Author
    Posts
  • July 9, 2008 at 10:35 am #37973
    Steven
    Participant

    AEG B57414M (944185055) Oven

    Repaired this one back in April, not going on to pyro, there was some board damage, so replaced the main power card and door lock.
    worked ok after fitting, c/x has now gone to use it again and said it not going over the third bar on display which is around 230degrees for the door to lock for it to go onto pyro.

    Any one had any knowledge of this fault and probable cause?

    Steven

  • Author
    Posts
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.