- This topic has 0 replies, 1 voice, and was last updated 17 years, 9 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
AEG B57414M (944185055) Oven
Repaired this one back in April, not going on to pyro, there was some board damage, so replaced the main power card and door lock.
worked ok after fitting, c/x has now gone to use it again and said it not going over the third bar on display which is around 230degrees for the door to lock for it to go onto pyro.Any one had any knowledge of this fault and probable cause?
Steven
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.