Fisher and Paykel MW059AU error code 62

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › Fisher and Paykel MW059AU error code 62

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • July 16, 2008 at 2:38 am #38121
    eddiehan
    Participant

    First indication wash after wash cycle had finished wash motor and pump intermittant. Have checked pump okay. Water inlets ok. Checked control board but no obvious damage. checked RYB wires to motor, appear electrically okay.

    Error code 00111110

    Machine was repaired 3 monts ago and lid sensor replaced and tremor off balance sensor replaced.

    Any help appreciated

    July 16, 2008 at 10:19 am #257787
    Penguin45
    Participant

    Re: MW059AU error code 60

    62 – pump fault.

    Penguin45.

    July 17, 2008 at 9:54 am #257788
    eddiehan
    Participant

    Re: MW059AU error code 60

    Thanks Penguin on interpreting error code, appears I can’t add up or type.

    Removed the pump and it runs ok on mains power.

    Inspected the two Triacs that control power, they appear ok. Have also manually controlled pumpout from front panel.

    Have checked all diodes and they appear ok, even paralleled corroded pcb track with hookup wire, but repair illudes me.

    Also how do I cancel flashing leds when washing machine is turned “on” at the power switch.

    Can anyone help give me another clue other than replacing control board.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.