WMA10 Wiring

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › WMA10 Wiring

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • July 18, 2008 at 2:35 pm #38177
    legsthediver
    Participant

    I’m a tosser… just done bearing job on it, rebuilt and got no pump-out :-((( Wiring back to board, I’ve got 2 blocks. 1 to p/switch and 1 to pump. with THREE possible locations… x11, x9 and x6… All my manuals stop at wm. Thanks as usual.. Legsthetosser…

    July 18, 2008 at 2:56 pm #257980
    hotpnt
    Participant

    Re: WMA10 Wiring

    hi, the pic in manual is not clear enough to see board markings, but, next to the valve block is the pump, then p/sw next along again, then an empty space & thermistor at end, hth

    July 18, 2008 at 3:05 pm #257981
    legsthediver
    Participant

    Re: WMA10 Wiring

    ta hotpnt… my prob is that there are 3 possible locations next to valve block.. then a space….

    July 18, 2008 at 4:04 pm #257982
    iadom
    Moderator

    Re: WMA10 Wiring

    Pump to X9, Pressure switch to X6 Thermistor to X2.

    I do it from memory looking down on the board from right to left, plastic covered amp tag, bare amp tag, square block into back of selector switch, large block to motor & door, then five way block,thenblue/black,.black/black then usually red/red to X2.

    Jim.

    July 18, 2008 at 4:34 pm #257983
    hotpnt
    Participant

    Re: WMA10 Wiring

    ha, i go the other way, red wires, then empty, 2 black wire, black/blue, then whites, plug, unilnsulated, insulated,

    July 18, 2008 at 5:01 pm #257984
    legsthediver
    Participant

    Re: WMA10 Wiring

    Thanks :-))) P.S. I MAY have tried running it with the 2 blocks the wrong way . . could i have caused any damage ????? Reason I’m askin is coz The blocks are now in correct position, and I’ve STILL got no pump action… I’m gonna be GUTTED if I’ve “Blown” it :-((( Cheers Boys.. Legs..

    July 18, 2008 at 6:40 pm #257985
    iadom
    Moderator

    Re: WMA10 Wiring

    hotpnt wrote:ha, i go the other way, red wires, then empty, 2 black wire, black/blue, then whites, plug, unilnsulated, insulated,

    Must be because I am left handed. I hold the console with my right hand. 🙂

    July 18, 2008 at 8:19 pm #257986
    hotpnt
    Participant

    Re: WMA10 Wiring

    no, im a leftie too 😆

    would not think it would blow the pump or module, if it had would expect the blown are to be very notable

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.