Refitting top cover AEG Oko Lavamat 72620

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Refitting top cover AEG Oko Lavamat 72620

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • July 23, 2008 at 6:48 am #38264
    potatan
    Participant

    Hi,

    I replaced the water distributor in my machine last night, not too difficult once the relevant panels have been removed / loosened. But I am struggling to refit the top cover of the machine, held by two screws fitted vertically (upwards) at the back of the appliance.

    Whilst I was very careful to note which screws went into which holes, I forgot to remember(!) which way the top cover was removed.

    It looks as though you line it up maybe 5mm back from the front edge then give it a shove from back to front to line up the screw holes, but I can’t seem to get it to seat properly.

    Any ideas?

    Thanks in advance
    Paul

    July 23, 2008 at 9:50 am #258292
    iadom
    Moderator

    Re: Refitting top cover AEG Oko Lavamat 72620

    No magic, sometimes the front edge of the top can be quite difficult to locate back into the front console trim, perseverence is the only way. 😉

    Jim.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.