Hotpint E6005 Hob

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpint E6005 Hob

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • July 29, 2008 at 8:54 pm #38396
    rocker
    Participant

    Fitted new glass to this hob (touch sensor controls) tested when finished.
    all sensors work except the + control dosent work but the minus does..customer not but I dont feel I have done anything wrong, as when fitting the glass it sits directly onto the sensors and dont believe they can be ajusted..
    can anyone advise me please..Cheers john.

    July 29, 2008 at 9:18 pm #258742
    hotpnt
    Participant

    Re: Hotpint E6005 Hob

    did you raise the glass back off again after to see if all the springs on the touch module were correctly in place?

    July 29, 2008 at 9:41 pm #258743
    rocker
    Participant

    Re: Hotpint E6005 Hob

    No didnt see any visiable springs nothing became loose, just Changed over glass onto the sensors, could I have dislodged one without knowing.
    Cheers John

    July 29, 2008 at 10:20 pm #258744
    hotpnt
    Participant

    Re: Hotpint E6005 Hob

    thats all i can think of, the board is mounted on springs to get a good contact with glass, either that or the glass may not have fully seated onto the board? hth

    July 29, 2008 at 10:31 pm #258745
    rocker
    Participant

    Re: Hotpint E6005 Hob

    Thanks hotnt, worth a recall to check. john.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.