Whirlpool ADP8322 dishwasher

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Whirlpool ADP8322 dishwasher

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • July 30, 2008 at 7:15 pm #38418
    GCK
    Participant

    A customer’s Whirlpool ADP8322 dishwasher is stopping the programme after about 3-4 minutes and showing an F7 fault (7 flashes). It runs through the test programme in 10 minutes but does not display any fault codes.
    Having read other postings I am suspecting the flow meter but there doesn’t seem to be any water running past the sensor when the machine is filling.
    The intake valve is working as the machine fills in a reasonable time, the solenoid on the water softener tests out OK and I have already replaced the WI.
    I am beginning to suspect the module.
    Any suggestions would be very welcome.

    August 3, 2008 at 6:53 pm #258811
    robwash
    Participant

    Re: Whirlpool ADP8322 dishwasher

    If you had a sam meter you can reprogramme control board and 9 times out of 10 the f7 will clear. If you change the flow meter it will definately clear the fault. I’ve never changed a valve for f7 but it could happen

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.