- This topic has 9 replies, 6 voices, and was last updated 17 years, 8 months ago by
.
-
Posts
-
Customer original complaint was of on spin the rinse orange led and the ‘two drip’ red led were showing. Brushes to stubs, so replaced. Now it seems its getting the same code on the last rinse. It has passed every test I’ve given it but when the customer uses it, it fails.
Any help appreciated.TC
Re: Neff v4280w1gb/08 fault code?
Been getting a lot of motor failures after brush changes over the last few years. New brushes, all seems fine – armature cooks under load within a few washes, safety starts dropping out……..
Chris.
Re: Neff v4280w1gb/08 fault code?
😕
Drum turning ok. Customer now reports once stopped towards the end of the spin and yesterday stopped without taking the conditioner. Both gave the same code. Is there a list of the codes for these available?TC
Re: Neff v4280w1gb/08 fault code?
I’ve had a couple where the carbons have gone only to find its a result of the motor failing. not good on a “quality” machine.
wilf
Re: Neff v4280w1gb/08 fault code?
If the customer re-selects the spin when it stops does it spin ok???
Could be an intermittant pump fault??
Re: Neff v4280w1gb/08 fault code?
Here’s my twopenneth…….
Likely suspects: –
Earthing fault on motor?
Crud in Air Pressure Chamber?
Open circuit inlet valve coil?
- You must be logged in to reply to this topic.