Neff S5433X0GB/13

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #38876
    Toni
    Participant

    Hi
    I have been to the above dishwasher with a no filling fault
    I cleaned the hose from the pressure chamber (Which was completeley blocked) and I have to order a pressure chamber (again blocked), but I am not sure about the aqua stop device. will this need to be replaced also ? or can they be reset.

    I have never had a problem with an aquastop device so I am not sure if there is a problem with it.

    Regards
    Toni

    #260235
    Martin
    Participant

    Re: Neff S5433X0GB/13

    Toni wrote: but I am not sure about the aqua stop device. will this need to be replaced also ? or can they be reset.

    The solenoid valve within the aquastop unit may have become open circuit? To reset the aquastop water block device simply requires the water turning off, the coupling loosened to allow it to vent, then reconnect and turn the stopcock on again.

    Once you’ve cleaned and/or replaced the Pressure Chamber and transfer hose and the base is clean, dry and ready to go. Reset the programme module and hopefully it should burst into life again.:wink:

    I did have one once (not same model but close) that would not fill and oddly enough it turned out to be caused by the drain pump. The wires were linked and the coil was drawing too much current – quite a headscratcher that turned out to be let me tell you. :rolls: Hopefully your pump is working fine?

    #260236
    Toni
    Participant

    Re: Neff S5433X0GB/13

    Thanks Martin
    Yes the pump is ok as it does come on when you reset the programe
    All you get when you switch it on is the pump coming on for a couple of minutes then a very slight humming noise and nothing else
    Toni

    #260237
    Martin
    Participant

    Re: Neff S5433X0GB/13

    Presumably the humming noise coming directly from the aquastop ?

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.