- This topic has 5 replies, 5 voices, and was last updated 17 years, 7 months ago by
.
-
Posts
-
Hi. I have problems with this dishwasher in which the lower spray arm is not rotating. it was blocked but i believe the diverter valve or pcb is faulty. It seems to only be rotating the upper spray arm… water is coming out of the lower one but not at enough pressure??? is it more likely to be a diverter valve problem or pcb?? i think i can hear the pcb relays clicking quite a bit during cycle?
Re: bosch d/washer sgs55c02gb/01
Diverters jam and break. Cycle time approx 50 seconds. If it hasn’t got a power supply, it’s the board. If it has and it don’t cycle, it’s heater box time.
Chris.
Re: bosch d/washer sgs55c02gb/01
By far the easiest/quickest test is to lift the top spray pipe from the heater box cover. If you can rotate the diverter cam with a small screwdriver its drive gear has become disengaged. The most common failing on these and new Heater unit required.
The other ‘water point’, but less common, failing is that the gearing grey rubber water seal leaks into the drive motor and either floods the base, blows the module up or both! 😉
Re: bosch d/washer sgs55c02gb/01
thanks alot guys!! i suspect jamed diverter then.. i did remove the grey ducting i tried pushing the diverter round but was so stiff didnt wanna break it… so i guess this is the problem… will give it ago. Thanks again.
😳
- You must be logged in to reply to this topic.