IKEA / Whirlpool DWH B10 error code = 7 flashes

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › IKEA / Whirlpool DWH B10 error code = 7 flashes

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • September 10, 2008 at 3:02 pm #39376
    wildsage
    Participant

    2 year old integrated IKEA / Whirlpool DWH B10 dishwasher. The machine gives an error code of 7 flashes, pause, 7 flashes, pause etc. accompanied by a long beep, a pause, long beep, pause etc.

    Machine is connected to a hot fill (red pipe). Water inlet temp = 50 to 55 deg C.

    Seems to happen at the start of most wash cycles just after the machine starts to fill. To clear the fault, I have to end the programme manually, switch off, switch back on, select the next programme (50 deg wash), press start then usually it pumps out, refills and does a perfect wash.

    This does not happen all of the time. Any ideas?

    I’ve checked filters, strainer, basket and spray arms. All OK and clean. I do a Finish orange dishwasher degreaser on the top wash every 6 months. Machine very well looked after.

    Anybody help? Don’t fancy getting my marogolds out 😥

    September 10, 2008 at 7:41 pm #262277
    Penguin45
    Participant

    Re: IKEA / Whirlpool DWH B10 error code = 7 flashes

    Flow meter failure. If it’s intermittent, it will almost certainly be a poor contact. The flow meter is under the left hand side panel – remove connector, clean, pinch and reconnect. Usually does the trick.

    Power off, first.

    Penguin45.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.