- This topic has 1 reply, 2 voices, and was last updated 17 years, 6 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
hello there problem is appliance fills starts turning then flashes up f10 ive been told its a pressure switch fault but that tests ok tested the heater and checked the sump for blockages do the boards go cant see anything blown
is this a pressure switch error?
any advise???
regards
mikeRe: hotpoint wf860p f10
Moved to Trade Technical, you stand a better chance of getting an answer here than in the public forums. 😉
When you say you ‘have been told’ did you not check in the Known Error codes thread, or have you not yet purchased the Fault code bible?
F10 is supposed to be pressure switch not sensing, the switch itself is very prone to failure but it often comes down to a faulty PCB, they also fail for fun. 😥
Jim.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.