Smeg SUK62MFX5

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Smeg SUK62MFX5

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • October 3, 2008 at 6:59 pm #39939
    rocker
    Participant

    Looking at fitting a new main oven stat..on connect site advising that org diamond h, is now changed to a ego version stat (part No 818730401)…is this a stright forward change over, or have the wiring configeration changed , if so do they supply a wiring diagram.
    any advice please John.

    October 3, 2008 at 7:05 pm #264213
    Lawrence
    Participant

    Re: Smeg SUK62MFX5

    If its the main oven stat and not an energy regulator there is only two wires on it .
    Lawrence

    October 3, 2008 at 7:29 pm #264214
    rocker
    Participant

    Re: Smeg SUK62MFX5

    cheers Lawerance, makes sense, was a bit conncerned as connect were advising to contact smeg for any tec info on this part.

    October 5, 2008 at 4:52 pm #264215
    eastlmark
    Moderator

    Re: Smeg SUK62MFX5

    Have to be careful on some of these as the off position sometimes is 45 degrees out, you may also need to change the “square” it mounts on. If its a MFX5 version you should be alright though as its a later one than the one with the problems.

    October 5, 2008 at 5:59 pm #264216
    rocker
    Participant

    Re: Smeg SUK62MFX5

    Eastlmark, not quite sure what you mean by change the square, dosent the stat fit directly into switch selector, I am not sure please let me know.
    Thanks John.

    October 5, 2008 at 6:37 pm #264217
    Lawrence
    Participant

    Re: Smeg SUK62MFX5

    put the knob on ifi ts “out”slacken of the alan key screw in the centre & turn the knob outer round until it points to 12 oclock then retighten screw .
    Lawrence

    October 5, 2008 at 7:22 pm #264218
    rocker
    Participant

    Re: Smeg SUK62MFX5

    Thanks Lawrence will do. John

    October 6, 2008 at 12:18 pm #264219
    eastlmark
    Moderator

    Re: Smeg SUK62MFX5

    sorry to confuse, I was thinking it was the stat on its own rather than the one clipped into the comm switch. the “square” is the metal plate to which the seperate type stat mounts on to.

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.